Filter
Top Products
privilege level, and has access to only two commands, end and exit. Individually specify each
CONFIGURATION mode command to which you want to allow access using the privilege
configure level level command. In the command, specify the privilege level of the user or terminal
line, and specify
all keywords in the command to which you want to allow access.
Allowing Access to INTERFACE, LINE, ROUTE-MAP, and ROUTER Mode
1. Similar to allowing access to CONFIGURATION mode, to allow access to INTERFACE, LINE, ROUTE-
MAP, and ROUTER modes, first allow access to the command that enters you into the mode. For
example, allow a user to enter INTERFACE mode using the privilege configure level level
interface gigabitethernet command.
2. Then, individually identify the INTERFACE, LINE, ROUTE-MAP or ROUTER commands to which you
want to allow access using the privilege {interface | line | route-map | router}
level
level command. In the command, specify the privilege level of the user or terminal line and
specify all keywords in the command to which you want to allow access.
Customizing a Privilege Level
to customize a privilege level, use the following commands.
1. Remove a command from the list of available commands in EXEC mode.
CONFIGURATION mode
privilege exec level level {command ||...|| command}
2. Move a command from EXEC Privilege to EXEC mode.
CONFIGURATION mode
privilege exec level level {command ||...|| command}
3. Allow access to CONFIGURATION mode.
CONFIGURATION mode
privilege exec configure level level
4. Allow access to INTERFACE, LINE, ROUTE-MAP, and/or ROUTER mode. Specify all keywords in the
command.
CONFIGURATION mode
privilege configure level level {interface | line | route-map | router}
{command-keyword ||...|| command-keyword}
5. Allow access to a CONFIGURATION, INTERFACE, LINE, ROUTE-MAP, and/or ROUTER mode
command.
CONFIGURATION mode
privilege {configure |interface | line | route-map | router} level level
{command ||...|| command}
Create a Custom Privilege Level Apply a Privilege Level to a Username
The following configuration privilege level 3. This level:
• removes the resequence command from EXEC mode by requiring a minimum of privilege level 4
• moves the capture bgp-pdu max-buffer-size command from EXEC Privilege to EXEC mode by
requiring a minimum privilege level 3, which is the configured level for VTY 0
Management
63