– mask: prefix length is from 0 to 128.
NOTE: IPv6 addresses are normally written as eight groups of four hexadecimal digits, where
each group is separated by a colon (:). Omitting zeros is accepted as described in Addressing.
SNMP over IPv6
The simple network management protocol (SNMP) is supported on the MXL switch platform.
You can configure SNMP over IPv6 transport so that an IPv6 host can perform SNMP queries and receive
SNMP notifications from a device running IPv6. The Dell Networking OS SNMP-server commands for
IPv6 have been extended to support IPv6. For more information regarding SNMP commands, refer to the
SNMP and SYSLOG chapters in the Dell Networking OS Command Line Interface Reference Guide.
• snmp-server host
• snmp-server user ipv6
• snmp-server community ipv6
• snmp-server community access-list-name ipv6
• snmp-server group ipv6
• snmp-server group access-list-name ipv6
Showing IPv6 Information
All of the following show commands are supported on the MXL switch platform.
View specific IPv6 configuration with the following commands.
• List the IPv6 show options.
EXEC mode or EXEC Privileged mode
show ipv6 ?
Example of show ipv6 Command Options
Dell#show ipv6 ?
accounting IPv6 accounting information
cam IPv6 CAM Entries
fib IPv6 FIB Entries
interface IPv6 interface information
mbgproutes MBGP routing table
mld MLD information
mroute IPv6 multicast-routing table
neighbors IPv6 neighbor information
ospf OSPF information
pim PIM V6 information
prefix-list List IPv6 prefix lists
route IPv6 routing information
rpf RPF table
Dell#
Showing an IPv6 Interface
To view the IPv6 configuration for a specific interface, use the following command.
IPv6 Addressing
471
