Filter
Top Products
Interface Te 0/20
Drop-statistic Dropped Pkts
Green 11234
Yellow 12484
Out of Profile 0
Dell#
Displaying egress-queue Statistics
To display egress-queue statistics of both transmitted and dropped packets and bytes, use the following
command.
• Display the number of packets and number of bytes on the egress-queue profile.
EXEC Privilege mode
show qos statistics egress-queue
Example of the show qos statistics egress-queue Command
Dell#show qos statistics egress-queue
Interface Te 1/1
Unicast/Multicast Egress Queue Statistics
Queue# Q# Type TxPkts TxBytes DroppedPkts DroppedBytes
--------------------------------------------------------------------------------
--
0 UCAST 0 0 0 0
1 UCAST 0 0 0 0
2 UCAST 0 0 0 0
3 UCAST 0 0 0 0
4 UCAST 0 0 0 0
5 UCAST 0 0 0 0
6 UCAST 0 0 0 0
7 UCAST 0 0 0 0
8 UCAST 204 13056 0 0
9 MCAST 0 0 0 0
10 MCAST 0 0 0 0
11 MCAST 0 0 0 0
12 MCAST 0 0 0 0
13 MCAST 0 0 0 0
14 MCAST 0 0 0 0
15 MCAST 0 0 0 0
16 MCAST 0 0 0 0
17 MCAST 0 0 0 0
Dell#
Classifying Layer 2 Traffic on Layer 3 Interfaces
To process Layer 3 packets that contain Dot1p — (IEEE 802.1p) Packet classification (Layer 2 headers),
configure VLAN tags on a physical Layer 3 interface (that is configured with an IP address and is not
associated with any VLAN). You can also configure a VLAN subinterface over a physical underlying
interface and classify packets using the dot1p value.
To apply an input policy map to Layer 3 physical interfaces, use the service-policy input policy-
name layer 2 command in Interface Configuration mode.
748
Quality of Service (QoS)