Filter
Top Products
FortiAnalyzer Version 3.0 MR7 Administration Guide
126 05-30007-0082-20080908
Configuring reports Reports
When configuring the FortiAnalyzer unit to email a report, you must first configure
the FortiAnalyzer unit to connect to an email server. For more information, see
“Configuring alerts by email server” on page 135.
If HTML reports are sent to a user that has an email client without supported
HTML, the HTML code for the reports will display in the message body.
You cannot delete a report output configuration if it is already being used in
another report.
Figure 7: Output template
To configure the output for a report
1 Go to Report > Config > Output.
2 Select Create New.
3 Enter and/or select the appropriate information for the fields and check boxes for
the following:
E-Mail Destination The route the email will take when sent, in the format,
<recipient_email address> (from <sender_email address> through
<email server>).
FTP/SFTP/SCP Server
IP
The type of server that the report will be uploaded to in the format,
<ipv4>(typeofserver). For example, 10.10.20.15(FTP).
Action Select Edit to view or modify the report output.
Select Delete to remove the report output.
Name Enter a name for the report. This name only concerns the report
output configuration that you are configuring for your report., not
the report itself.
Description Enter a description for the report. This is optional.