Filter
Top Products
FortiAnalyzer Version 3.0 MR7 Administration Guide
34 05-30007-0082-20080908
Dashboard System
Resetting to the default configuration
You can reset the FortiAnalyzer unit to its default configuration.
Resetting the configuration does not restore the original firmware. Configuration
and firmware are distinct. Use the procedures in “Managing firmware versions” on
page 169 for managing firmware.
To reset to the default configuration
1 Go to System > Dashboard.
2 In the System Operations area, select Reset.
3 Select OK to confirm.
The FortiAnalyzer unit restarts with the default configuration for the currently
installed firmware version.
Alert Message Console
The Alert Message Console displays alert messages for the FortiAnalyzer unit
and connected devices, including hard disk failure messages, virus outbreak, or
suspicious event warnings.
To set the threshold for Alert Message Console, or to view all the alert messages
recorded by the FortiAnalyzer unit, select More alerts. For more information about
viewing alert messages, see “Viewing alert console messages” on page 34.
Viewing alert console messages
Alert console messages provides a window on what is occurring on the
FortiAnalyzer and other FortiGate devices. These messages allow you to view
issues on your network, including network attacks and virus warnings.
The Alert messages window provides a complete list of alert messages. You can
view the alert messages by level or acknowledge the messages as required.
Acknowledging an alert message removes it from the list of alerts.
Alert messages can also be delivered by email, Syslog or SNMP. For more
information, see “Alert Events” on page 133.
To view alert console messages
1 Go to System > Dashboard.
2 Select More Alerts in the upper right corner of the Alert Message Console area.
3 Select the column headers to sort the column in ascending or descending order.
!
Caution: Back up the configuration before resetting. Resetting the configuration deletes all
changes you have made to the FortiAnalyzer configuration, reverting it to the firmware’s
default configuration, including resetting interface IP addresses.