Filter
Top Products
Managing firmware versions Restoring your configuration
FortiAnalyzer Version 3.0 MR7 Administration Guide
05-30007-0082-20080908 181
6 When this message appears:
Press any key to display configuration menu...
immediately press a key to interrupt the system startup.
If you successfully interrupt the startup process, the following messages appears:
[G]: Get firmware image from TFTP server.
[F]: Format boot device.
[B]: Boot with backup firmware and set as default.
[Q]: Quit menu and continue to boot with default firmware.
[H]: Display this list of options.
Enter G,F,B,Q,or H:
7 Type G to get the new firmware image from the TFTP server.
The following message appears:
Enter TFTP server address [192.168.1.168]:
8 Type the address of the TFTP server and press Enter.
The following message appears:
Enter Local Address [192.168.1.188]:
9 Type an IP address for the FortiAnalyzer unit and press Enter.
The FortiAnalyzer unit will temporarily assign this IP address to the interface to
connect to the TFTP server and download the firmware.
This IP address can be any IP address that is valid for the network the interface is
connected to, as long is it does not conflict with another device on this network.
The following message appears:
Enter File Name [image.out]:
10 Type the firmware image file name and press Enter.
The TFTP server uploads the firmware image file to the FortiAnalyzer unit. The
CLI displays messages as it downloads and verifies the firmware image:
MAC:00090F601129
################
Total 17268465 bytes data downloaded.
Verifying the integrity of the firmware image.
Total 28000kB unzipped.
When the upload is complete, the CLI displays the following message:
Save as Default firmware/Backup firmware/Run image without
saving:[D/B/R]
11 Type D.
The FortiAnalyzer unit installs the new firmware image and restarts.