Filter
Top Products
System Network
FortiAnalyzer Version 3.0 MR7 Administration Guide
05-30007-0082-20080908 45
Changing interface settings
To change the interface settings
1 Go to System > Network > Interface.
2 In the row corresponding to the interface you want to change, select Modify.
3 Configure the following options:
4 Select OK.
Status The status of the network interface.
• A green arrow indicates the interface is up. Select Bring Down
to disable the port.
• A red arrow indicates the interface is down. Select Bring up to
enable the port.
Modify Select Modify to change the interface settings.
Interface Name The interface name is cannot be changed.
Fortinet Discovery
Protocol
Select Enabled to allow responses to Fortinet Discovery Protocol
(FDP) on the interface, allowing FortiGate devices to find the
FortiAnalyzer unit automatically. For more information about FDP,
see “About Fortinet Discovery Protocol” on page 47 and “Manually
adding a FortiGate unit using the Fortinet Discovery Protocol
(FDP)” on page 85.
IP/Netmask Enter an IP address and network mask.
Administrative
Access
Select which methods of administrative access should be
available on this interface.
• HTTPS allows secure HTTPS connections to the FortiAnalyzer
web-based manager.
• PING allows response to ICMP pings, which are useful for
testing connectivity.
• HTTP allows HTTP connections to the FortiAnalyzer
web-based manager.
HTTP connections are not secure and can be intercepted by a
third party.
• SSH allows SSH connections to the FortiAnalyzer CLI.
• TELNET allows Telnet connections to the FortiAnalyzer CLI.
Telnet connections are not secure, and can be intercepted by a
third party.
• AGGREGATOR assigns the port to be the sender or receiver
of log aggregation transmissions. For more information about
aggregation, see “Configuring log aggregation” on page 58.
• WEBSERVICES allows web service (SOAP) connections.
FortiManagerunits require web service connections for remote
management of FortiAnalyzer units. If this option is not
enabled, the FortiManager unit will not be able to install a
configuration on the FortiAnalyzer unit.