Filter
Top Products
Chapter 6 Novell Host Configuration (10/100Base-T)
104
2. You should now see a prompt displayed that has the PrintNet’s IP
address followed by a colon then root.
ipaddress
:root>
3. At the prompt, enter:
store pserver novell tree
tree
4. Reset the unit to make the changes take effect.
reset
Novell Host Configuration (10/100Base-T)
This section covers PSERVER and RPRINTER/NPRINTER setups on the
PrintNet. The PrintNet can handle up to eight RPRINTER/NPPRINTER
setups.
Even though the entire print setup is done through Netware Administrator
or PCONSOLE, you may need to communicate directly with the print
server in order to modify settings, monitor the unit, etc.
For Netware 4.x environments, you can obtain a NWAdmn3x snap-in
program called MPAdmin. This snap-in can be used to configure
PSERVER setups as well as additional settings on the PrintNet.
NOTE: NWAdmn3x is only included with Netware 4.11 and higher
releases. If you are using Netware 4.10, you can either upgrade
to Netware 4.11, or go to Novell’s web site and get the patches to
upgrade the Nwadmin program for Netware 4.10 to Nwadmn3x
for Netware 4.11. Alternatively, you can perform the setup without
using MPAdmin.
NDS PSERVER Setup (Netware 4.x)
There are a number of possible ways to configure the PrintNet for use in a
Novell NDS PSERVER setup. These include using the MPAdmin snap-in
for Netware Administrator, using generic print server objects in Netware
Administrator, or by using PCONSOLE. The following steps describe a
setup using generic print server object in Netware Administrator. Setups
using PCONSOLE are less common, and will not be discussed.