Filter
Top Products
Chapter 1 Interfaces
18
10/100Base-T
The PrintNet interface card at the rear of the printer for the 10/100Base-T
interface has two indicator lights, shown in Figure 2.
Figure 2. Status Indicator Lights and Dipswitches (10/100Base-T)
Run and Auto Reset Modes
Run Mode is the normal operating state of the PrintNet. Auto Reset mode
is entered when the watchdog timer is triggered and the Print Server
resets itself. In either mode, the STAT LED flashes at a varying rate,
depending on whether the unit IP address is configured. The Run Mode
and Auto Reset Mode indicator descriptions are given in Table 4.
STAT (System Status)
NET (Data to Network)
12
DIP Switches
Table 4. Run Mode and Auto Reset Mode Indicator Descriptions
STAT Rate Indication
OFF flashes on once per second Normal Mode, IP address
configured
OFF flashes on 2 times per second IP address not configured
ON flashes off once per second Download (MOS)
ON flashes off twice per second Error
ON constantly Indicates link integrity
ON flashes off 1/3 second Flashes off 1/3 second each
time a packet is transmitted