Filter
Top Products
10/100Base-T
19
Network Indicator
The NET LED displays the status of the network link. When the NET LED
is on, this confirms link integrity. The NET LED flashes off for 1/3 second
when a data packet is being transferred. When the NET LED is off, the
network connection has been severed.
Dipswitches
On the back of the 10/100Base-T interface, you will find a small window
where you can access two dipswitches labeled 1 and 2 (see Figure 2).
The functions of the dipswitches are explained in Table 5.
Table 5. 10/100Base-T Dipswitch Settings
Dipswitch
Comments
12
off off Normal operation. With both dipswitches in the “off”
position, the PrintNet boots up using the settings in
flash memory rather than the default settings.
on off Factory default settings. With the dipswitches in this
configuration, the PrintNet boots up and all settings
stored in flash memory are erased except the Ethernet
address and key value.
off on Default IP. With the dipswitches in this configuration,
the PrintNet boots up with factory default settings.
However, the stored settings in flash memory are
intact. Setting dipswitch 2 to “on” does not clear any
settings stored in flash memory; it boots the unit in a
different state with the settings in flash memory
temporarily ignored.
on on If the PrintNet is connected to a network with link
integrity and then reset to MOS, a download will be
forced. If the unit is not connected to a network, it will
print a test page.