Filter
Top Products
TCP/IP Access Problem
73
3. On the PrintNet, place SWITCH 2 in the down position.
4. Power on the printer and wait for the ONLINE state.
5. On the PrintNet, place SWITCH 2 in the up position.
6. From a workstation attached to this network segment, create an ARP
entry. The PrintNet IP address and hardware or MAC address are
needed. At the workstation enter:
arp -s <
ipaddress
> <
MACaddress
>
ping <
ipaddress
>
7. Try to “
ping
” this IP address to see if the PrintNet can be seen on
your network. If the interface does not respond, verify you are on the
same network segment as the printer and that the ARP entry was
created.
8. Telnet into the PrintNet using the same IP address as above. Log in
as root with no password.
9. At the system prompt, enter:
store tcpip from default
config http on
reset
NOTE: This will reset all TCP/IP settings to factory default and reset the
PrintNet.
10. Power the printer off and then back on.
11. Set the IP address, subnet mask, and default gateway parameters to
the desired values.
12. If Web browser access does not work, Telnet into the PrintNet as
root. Enter the following command:
config http on
If you are still experiencing difficulty accessing or browsing the printer,
contact technical support for further assistance.