Filter
Top Products
Set Commands
139
set time
hours
[
minutes
[
seconds
]]
set time 10 30
Set the current time noting the
hours
based on the 24-hour system
and the
minutes
and
seconds
ranging from 0 through 59. If the
PrintNet is reset, this value will be lost so you will need to set the time
again.
set user add|del
username
set user add eng
Add or remove a user on the PrintNet defined by
username.
IMPORTANT
Be careful not to delete the root user, or you will be unable to
configure any further settings on the print server. You will have to
go back to factory defaults to correct this problem.
set user passwd
username password
set user passwd eng mplex1
Assign a
password
to a defined user on the PrintNet. This
password
must be less than eleven characters.
set user type
username
root|guest
set user type eng root
Assign root or guest privileges to a particular user defined by
username
. Guest permissions allow viewing of settings only. Root
permissions allow complete control of the PrintNet.
set user from default
Set all user settings back to factory defaults.
set user from stored
Set all current user settings to the values stored in flash memory.
set user passwd snmp
com_name
Sets the new SNMP R/W community name as the
com_name
value.