Filter
Top Products
Chapter 8 Complete Command List
140
set var
variablename variablestring
set var LANDSCAPE 0x1b 0x26 0x6c 0x31 0x4f
set var FINISH $FF $PCL-RST
Define a new variable to be used in header, trailer, or switch strings
on the PrintNet and call it
variablename. variablestring
can be a
space-separated list of words, hexadecimal numbers (e.g., 0x04), or
references to other pre-defined variables. It is easiest to make up the
variablestring
with hexadecimal values as shown in the example.
NOTE: One variable counts as one element within header and trailer
strings.
NOTE: Defined variables are referenced in strings by placing a “
$”
before the variable name (e.g., “
set model m1 trailer
$FF
”).
set var from default
Set all variable settings back to factory defaults.
set var from stored
Set all current variable settings to the values stored in flash memory.
List Commands
These commands list the current or working settings for a particular
section within the command shell. To view stored settings in flash
memory, you will need to add in “
stored” within the beginning of any of
the following commands. For example, “
list prn” shows you the
current prn settings but “
list stored prn” shows you the settings
sitting in flash memory. Normally these should match.
list arp
List the current ARP table that the PrintNet adheres to in a TCP/IP
network.
list date
List the current date on the PrintNet.
list dest
List the current destination settings (e.g. names and mapped I/O
ports, models, and logpaths).