Filter
Top Products
2. Insert the Windows CD that came with your HP All-in-One into the CD-ROM drive
on your computer and follow the onscreen instructions.
3. If a dialog box pertaining to firewalls appears, respond as follows:
– The Issues Stopping Installation screen means that a firewall or anti-
spyware program is running that may interfere with the HP Software
Installation. For best results temporarily disable the firewall or anti-spyware
programs during installation. See your firewall documentation for instructions.
After the installation is complete you can re-enable the firewall or anti-
spyware programs.
– The Notice about Firewalls means that the Microsoft Internet Connection
Firewall is enabled. Click Next to allow the Setup program to open the
necessary ports and continue with the installation. If a Windows Security
Alert appears for a program published by Hewlett-Packard, please unblock
this program.
4. On the Connection Type screen, select Through the network, and then click
Next.
The Searching screen appears as the Setup program searches for your HP All-in-
One on the network.
5.
On the Printer Found screen, verify that the printer description is correct.
If more than one printer is found on the network, the Printers Found screen
appears. Select the device you want to connect.
To see the device settings on your HP All-in-One:
a. Go to the control panel on your device.
b. Select View Network Settings on the Network Menu, and then select
Display Wired Summary.
6. If the device description is correct, select Yes, install this printer.
7. At the prompt, restart your computer to finish the installation process.
When you have finished installing the software, your HP All-in-One is ready for
service.
8. If you disabled a firewall or virus detection software on your computer, make sure
to enable it again.
9. To test your network connection, go to your computer and print a self-test report
to your HP All-in-One. For more information, see Print a self-test report.
To install the Mac HP All-in-One software
Note The following instructions are for Macs only.
1. Quit all applications running on your computer.
2. Insert the Mac CD that came with your HP All-in-One into the CD-ROM drive on
your computer.
3. Double-click the HP All-in-One installer icon.
4. (Mac OS X) On the Authentication screen, enter the Administrator password
used to access your computer or network.
The installer software looks for HP All-in-One devices, and then lists them.
5. (Mac OS X) On the Select Device screen, select your HP All-in-One.
Chapter 4
32 HP Photosmart 2570 All-in-One series
Network setup