Filter
Top Products
Problem Resolution5Ć12
Table 5-1. Information Codes on the HP FAX-700 and FAX-750 (Continued)
Info
Code
Mode Description of the Problem Action
473 Tx
NonĆECM
FCS error occurred and carrier continued
for T6" time in the subroutine to wait for
DTC/DIS commands
Resend fax
474 Tx
NonĆECM
DIS/DTC FIF bit 10 is not set to 1 Resend fax
475 Tx
NonĆECM
Received DCN command in the subrouĆ
tine to receive remote party response folĆ
lowing DCS/TCF transmission
Resend fax
476 Tx
NonĆECM
Frame error occurred ("T6" time passed)
in the subroutine to receive response from
the remote party following DCS/TCF transĆ
mission
Resend fax
477 Tx
NonĆECM
FCS error occurred in the subroutine to
receive response after sending DCS/TCF
Resend fax
478 Tx
NonĆECM
T6" time passed after reception of RCP in
the subroutine to receive response followĆ
ing DCS/TCF transmission
Resend fax
479 Tx
NonĆECM
Received DCN command in the subrouĆ
tine to receive response following MPS/
EOP/EOM transmission
Resend fax
480 Tx
NonĆECM
Frame error occurred in the subroutine to
receive response following MPS/EOP/
EOM transmission
Resend fax
481 Tx
NonĆECM
FCS error occurred in the subroutine to
receive response following MPS/EOP/
EOM transmission
Resend fax
482 Tx
NonĆECM
T6" time passed after reception of RCP in
the subroutine to receive response followĆ
ing MPS/EOP/EOM transmission
Resend fax
483 Tx
NonĆECM
Received RTN from the remote party after
sending EOM
Resend fax
501 Rx
NonĆECM
In the manual reception mode, did not reĆ
ceive response from remote fax within
T1" time after sending
(NSF)(CSI)DIS/(NSC)(CIG)DTC to it
Check for fax completeness. Check with
the remote party. Retry fax reception
502 Rx
NonĆECM
Could not receive the command from the
remote party within T2" time. Further, the
last command received was other than
EOM(PRIĆEOM) command. Or, could not
receive the message from the remote
party within T2" time. Further, the last
command received was other than
EOM(PRIĆEOM) command
Check for fax completeness. Check with
the remote party. Retry fax reception
503 Rx
NonĆECM
Received DIS command from the remote
party. Or, received NSS command but it
was not compatible
Check for fax completeness. Check with
the remote party. Retry fax reception