Filter
Top Products
Problem Resolution 5Ć65
Test Mode 1 (Changing Function Parameters) on the HP FAX-900 and FAX-950
The use of test mode 1 to change function parameters has already been described in this chapter under the following
heading, “Changing the Function Parameters on the HP FAX-900 and FAX-950 (Test Mode 1).”
Test Mode 3 (Listing Function Parameter Settings) on the HP FAX-900 and FAX-950
The use of test mode 3 to produce a list of function parameters has already been described in this chapter under the
heading, “Listing the Function Parameter Settings on the HP FAX-900 and FAX-950 (Test Mode 3).”
Test Mode 4 and Test Mode 5 (Factory Only) on the HP FAX-900 and FAX-950
These modes are used for factory or repair center testing.
Test Mode 6 (Initializing Fax Machine Memory) on the HP FAX-900 and FAX-950
Use test mode 6 to initialize the fax machine memory or to initialize the function parameters to their default settings.
Procedures for accomplishing initialization follow.
Caution Do not initialize the fax machine RAM to the “MANUFACTURE SET” setting. Doing so will
render the machine unusable.
To initialize the HP FAX-900 or FAX-950, perform the following procedure:
Menu
→
Dial/Space
Tone
→
x 4
→
L
PRS
→
7
Start
MNO
→
6
Note: It is possible to enter a code from Table 5-32 in order to initialize RAM data instead of
pressing ƞ or Ɵ to select the data to be initialized. The fax machine will immediately
initialize after the last digit of the code is pressed.
Start
→
Stop
Exit Note If, after cycling through the choices of RAM data to be initialized, you decide not to initialize any
of the choices, press the stop button twice to exit test mode 6 and return the fax machine to
standby mode.
1. With the fax machine in standby mode (message window showing date and time), press Menu, then press 7.
2. With the message window showing SET MODE NO. =, press Dial/Space four times. The unit sounds an error
beep each time you press Dial/Space. This is normal.