Filter
Top Products
Problem Resolution 5Ć37
Table 5-7. HP FAX-900 and FAX-950 Function Parameters (Continued)
No. Parameter Selection Function
18 RX START
(9600 bps)
1 = 2400 bps
2 = 4800 bps
3 = 7200 bps
4 = 9600 bps
Selects receiving modem start speed
19 Not Used
20 CCITT ECM
(On)
1 = Off (Invalid)
2 = On (Valid)
Selects ECM (Error Correction Mode)
status
21 EP TONE
(Off)
1 = Off (without EP tone)
2 = On (with EP tone)
Selects whether or not the fax ma-
chine will generate an echo protect
tone
22 SIG. INTERVAL
(500 ms)
1 = 100 ms
2 = 200 ms
3 = 300 ms
Selects the time interval between re-
ceiving a signal and transmitting a
signal
23 TCF CHECK
(Normal)
1 = Normal (Short)
2 = Long
Selects TCF (Transmit ConFirm)
check interval
24 CED FREQ.
(2100 Hz)
1 = 1080 Hz (non CCITT)
2 = 2100 Hz
Selects CED (CallED station identifi-
cation) frequency
25 COMM. START-UP
(1’st)
1 = 1’st response
2 = 2’nd response
Selects communication start-up
condition (XMT and polling)
26 NON-STANDARD
(On)
1 = Off (Invalid)
2 = On (Valid)
Selects own mode (Panafax mode).
27 SHORT PROTOCOL
(On)
1 = Off (Invalid)
2 = On (Valid)
Selects whether or not a short proto-
col will be used
28 Not Used
29 REMOTE DIAG
(On)
1 = Off (will not accept)
2 = On (accepts)
Selects whether or not the machine
accepts remote diagnostics from a
service station. Same function as fax
parameter 31. (This is only for ma-
chine-to-machine diagnostics)
30 CED & 300 bps
(75 ms)
1 = 75 ms
2 = 1 second
Selects blank time between CED
(CallED station identification) and 300
bps signal
31 RTC EOL x 12
(Off)
1 = Off (EOL x 6)
2 = On (EOL x 12)
Selects RTC (Return To Control) sig-
nal
32 CSI TRANSMIT
(On)
1 = Off (not transmitted)
2 = On (transmitted)
Selects whether or not to transmit the
CSI (Called Subscriber Identification)
signal
33 TSI TRANSMIT
(On)
1 = Off (not transmitted)
2 = On (transmitted)
Selects whether or not to transmit the
TSI (Transmitting Subscriber Identifi-
cation) signal
34 CIG TRANSMIT
(On)
1 = Off (not transmitted)
2 = On (transmitted)
Selects whether or not to transmit the
CIG (CallInG subscriber identifica-
tion) signal
35 Not Used
36 CHARACTER ID
(On)
1 = Off (not transmitted)
2 = On (transmitted)
Selects whether or not the machine
will transmit a character ID