Filter
Top Products
Control panel message Description Recommended action
onscreen dialog box. See Clear jams from
the document feeder. Also see Solve
repeated jams.
If the message persists after all jams have
been cleared, a sensor might be stuck or
broken. Contact an HP-authorized service
or support provider. See the HP support
flyer, or go to
http://www.hp.com/support/
ljm4345mfp.
Jam in document feeder Media is jammed in the document feeder. Follow the instructions in the onscreen
dialog box. See
Clear jams from the
document feeder. Also see Solve repeated
jams.
LDAP Server is not responding Contact
administrator
The LDAP server has exceeded the time
out value for an address request.
Verify the LDAP server address. See Solve
e-mail problems. Contact the network
administrator.
Load envelope feeder <type> <size>
The envelope feeder is empty.
Load the envelope feeder.
Load Tray 1 <type> <size> The tray is empty or configured for a
different size than the size requested.
Follow the instructions in the onscreen
dialog box.
Manually feed <type> <size> The specified job requires manual feed
from tray 1.
Load the requested media into tray 1.
To override the message, touch OK to use
a type and size of media that is available in
another tray.
Network connection required for Digital
Sending. Contact administrator.
A digital-sending feature has been
configured, but a network connection is not
detected.
Verify the network connection. See Solve
network printing problems. Contact the
network administrator.
Non HP supply installed Economode
disabled
A non-HP supply or a refilled HP supply
has been installed.
Follow the instructions in the onscreen
dialog box.
Novel login required Novell authentication has been enabled for
this destination.
Enter Novell network credentials to access
the requested feature.
Order cartridge The number of pages remaining for the
print cartridge has reached the low
threshold. The MFP was set to stop printing
when a supply needs to be ordered.
Touch OK to continue printing until the print
cartridge is out of toner.
To order a new print cartridge, see
Order
parts, accessories, and supplies.
Output bin <x> full The specified output bin is full and printing
cannot continue.
Empty the bin to continue printing.
Output paper path open The paper path between the MFP and the
output device is open and must be closed
before printing can continue.
1. If you have a 3-bin mailbox installed,
make sure the jam-access door is
closed.
2. If you have a stapler/stacker installed,
make sure the staple cartridge is
snapped into position and that the
staple-cartridge door is closed.
PAPER WRAPPED AROUND FUSER A jam has occurred because paper has
wrapped around the fuser.
Follow the instructions in the onscreen
dialog box. See
Clear jams.
Password or name is incorrect. Please
enter correct login.
The user name or password was typed
incorrectly.
Retype the user name and password.
Table 11-1 Control-panel messages (continued)
ENWW Control-panel messages 185