Menu item Sub-menu item Sub-menu item Values and Description
IPX/SPX Enable
Off: Disable the IPX/SPX protocol.
On (default): Enable the IPX/SPX protocol.
Frame Type Selects the frame-type setting for your network.
Auto: Automatically sets and limits the frame type to
the first one detected.
EN_8023, EN_II, EN_8022, and EN_SNAP: Frame-
type selections for Ethernet networks.
AppleTalk Enable
Off (default): Disable the AppleTalk protocol.
On: Enable the AppleTalk protocol.
DLC/LLC Enable
Off (default): Disable the DLC/LLC protocol.
On: Enable the DLC/LLC protocol.
Security Print Sec Page Yes: Prints a page that contains the current security
settings on the HP Jetdirect print server.
No (default): A security settings page is not printed.
Secure Web For configuration management, specify whether the
embedded Web server will accept communications
using HTTPS (Secure HTTP) only, or both HTTP
and HTTPS.
HTTPS Required: For secure, encrypted
communications, only HTTPS access is accepted.
The print server will appear as a secure site.
HTTP/HTTPS optional: Access using either HTTP or
HTTPS is permitted.
IPsec or Firewall Specify the IPsec or Firewall status on the print
server.
Keep: IPsec/Firewall status remains the same as
currently configured.
Disable: IPsec/Firewall operation on the print server
is disabled.
Reset Security Specify whether the current security settings on the
print server will be saved or reset to factory defaults.
No*: The current security settings are maintained.
Yes: Security settings are reset to factory defaults.
Diagnostics Embedded Test This menu provides tests to help diagnose network
hardware or TCP/IP network connection problems.
Embedded tests help to identify whether a network
fault is internal or external to the device. Use an
embedded test to check hardware and
communication paths on the print server. After you
select and enable a test and set the execution time,
you must select Execute to initiate the test.
Table 2-10 Jetdirect menus (continued)
ENWW Initial Setup menu 35