Filter
Top Products
Menu item Sub-menu item Sub-menu item Values and Description
Ping Results Use this item to view the ping test status and results
using the control panel display. You can select the
following items:
Packets Sent Shows the number of packets (0 - 65535) sent to the
remote host since the most recent test was initiated
or completed.
Packets Received Shows the number of packets (0 - 65535) received
from the remote host since the most recent test was
initiated or completed.
Percent Lost Shows the percent of ping test packets that were
sent with no response from the remote host since the
most recent test was initiated or completed.
RTT Min Shows the minimum detected roundtrip- time (RTT),
from 0 to 4096 milliseconds, for packet transmission
and response.
RTT Max Shows the maximum detected roundtrip- time (RTT),
from 0 to 4096 milliseconds, for packet transmission
and response.
RTT Average Shows the average round-trip-time (RTT), from 0 to
4096 milliseconds, for packet transmission and
response.
Ping In Progress Shows whether a ping test is in progress. Yes
indicates a test in progress, and No indicates that a
test completed or was not run.
Refresh When viewing the ping test results, this item updates
the ping test data with current results. Select Yes to
update the data, or No to maintain the existing data.
However, a refresh automatically occurs when the
menu times out or you manually return to the main
menu.
Link Speed The link speed and communication mode of the print
server must match the network. The available
settings depend on the device and installed print
server. Select one of the following link configuration
settings:
CAUTION If you change the link setting,
network communications with the print
server and network device might be lost.
Auto (default): The print server uses auto-negotiation
to configure itself with the highest link speed and
communication mode allowed. If auto-negotiation
fails, either 100TX HALF or 10TX HALF is set
depending on the detected link speed of the hub/
switch port. (A 1000T half-duplex selection is not
supported.)
10T Half: 10 Mbps, half-duplex operation.
10T Full: 10 Mbps, Full-duplex operation.
100TX Half: 100 Mbps, half-duplex operation.
Table 2-10 Jetdirect menus (continued)
38 Chapter 2 Control Panel ENWW