Filter
Top Products
Initial Setup menu
The Initial Setup menu contains the sub-menus shown:
●
Networking and I/O menu
●
Fax Setup menu
●
E-mail Setup menu
NOTE Values shown with "(default)" are the factory-default values. Some menu items have
no default.
Networking and I/O
Table 2-9 Networking and I/O
Menu item Sub-menu item Values Description
I/O Timeout Select a value in the
range. The factory
default setting is
15 seconds.
I/O timeout refers to the elapsed time before a print
job fails. If the stream of data that the device
receives for a print job gets interrupted, this setting
indicates how long the device will wait before it
reports that the job has failed.
Parallel Input
NOTE This
item appears
only if an EIO
accessory is
installed.
High Speed No
Yes (default)
Use the High Speed setting to configure the speed
that the parallel port uses to communicate with the
host.
Advanced Functions Enabled (default)
Disabled
Use the Advanced Functions setting to enable or
disable bidirectional parallel communication.
Embedded Jetdirect See Table 2-10 Jetdirect menus for the list of options.
EIO <X> Jetdirect
Table 2-10 Jetdirect menus
Menu item Sub-menu item Sub-menu item Values and Description
TCP/IP Enable Off: Disable the TCP/IP protocol.
On (default): Enable the TCP/IP protocol.
Host Name An alphanumeric string, up to 32 characters, used to
identify the device. This name is listed on the
HP Jetdirect configuration page. The default host
name is NPIxxxxxx, where xxxxxx is the last six
digits of the LAN hardware (MAC) address.
IPV4 Settings Config Method Specifies the method that TCP/IPv4 parameters will
be configured on the HP Jetdirect print server.
Bootp: Use BootP (Bootstrap Protocol) for automatic
configuration from a BootP server.
32 Chapter 2 Control Panel ENWW