Hitachi SJ300 Series Power Supply User Manual


 
Using Intelligent Input Terminals
Operations
and Monitoring
4–28
Thermistor
Thermal
Protection
Motors that are equipped with a thermistor can be protected from overheating. Input terminal
[TH] is dedicated to sense a thermistor resistance. The input can be set up (via B098 and B099)
to accept a wide variety of NTC or PTC type thermistors. Use this function to protect the motor
from overheating.
Opt.
Code
Symbol Function Name
Input
State
Description
TH Thermistor Thermal
Protection
Sensor
When a thermistor is connected between
to terminals [TH] and [CM1], the inverter
checks for over-temperature and will
cause a trip (E35) and turn OFF the output
to the motor
Open An open circuit in the thermistor causes a
trip, and the inverter turns OFF the output
Valid for
inputs:
[TH] only
Required
settings:
B098, B099, and C085
Notes:
Be sure the thermistor is connected to termi-
nals [TH] and [CM1]. If the resistance is
above or below (depending on whether NTC
or PTC) the threshold the inverter will trip.
When the motor cools down enough, the
thermistor resistance will change enough to
permit you to clear the error. Press the STOP/
Reset key to clear the error.
5 3 1
7 6 4 2
8
FW
TH
PLC
CM1
P24
CM1
Example:
See I/O specs on page 4–9.
TH
thermistor
Motor