Filter
Top Products
CEMT SET FILE
| NOLoad
| The coupling facility data table does not require loading
| from a source data set. It is fully usable as soon as it is
| created, and is populated entirely by the transactions
| that use it.
NORead
You cannot read records in the file.
NOTRls (
vsam only
)
The file is defined to be accessed in a non-RLS mode
(LSR or NSR).
For information about switching from RLS to non-RLS
mode, see the
CICS Recovery and Restart Guide
.
NOTTable
The file name does not represent a data table.
NOUpdate
You cannot update records in the file.
Old
The disposition of the data set associated with the file is
defined as unshared for dynamic allocation.
OPen
The file is open. If the file is OPEN ENABLED, it is
available for data accesses by CICS transactions. If it is
OPEN DISABLED, it must first be enabled before it is
available.
If the file was unenabled by a previous SET FILE
CLOSED command, the SET FILE OPEN command
reenables the file implicitly.
REAd
You can read records in the file.
| RECordsize
| specifies the maximum record size for a coupling facility
| data table that does not require pre-loading from a
| source data set.
| You can specify the record size for a file that does not
| currently refer to a coupling facility data table, but which
| could be switched to use a coupling facility data table at
| a later date. Specify a record size of 1- to 32767-bytes,
| or specify a record size of zero to remove a previously
| defined value.
RLs (
vsam only
)
The file is defined to be accessed in RLS mode.
Share
The disposition of the data set associated with the file is
defined as shared for dynamic allocation.
| Tablename(
value
)
| specifies the name of the table for a coupling facility
| data table.
UPdate
You can update records in the file.
USertable
The file name represents a user-maintained data table.
Chapter 11. Master terminal CEMT 183