Filter
Top Products
CEMT INQUIRE AUXTRACE
I AUX
RESULT - OVERTYPE TO MODIFY
Auxtrace
Curauxds(A)
Status( Stop )
Switchstatus( Noswitch )
Switchaction( )
Figure 51. The expanded display of an individual entry
─ ──CEMT Inquire AUXtrace ─
Displayed fields
Auxiliary
identifies this panel as relating to auxiliary trace.
Curauxds(
value
)
displays a 1-character identifier of the current auxiliary
data set, which can be ‘A’ or ‘B’. This value is blank if
there is no auxiliary trace data set.
STatus(
value
)
displays the status of auxiliary tracing in your CICS
system. The values are:
Start Auxiliary tracing is in progress (the auxiliary trace
data set is open).
Pause
Auxiliary tracing has stopped, but the trace data
set has been left open. A subsequent START
request causes trace entries to be written
immediately following those that were written
before the PAUSE request.
Stop Auxiliary tracing has stopped, and the trace data
set is closed.
Note: You can reset this value by overtyping it with a
different value.
SWITCHAction(
value) (input only field
)
specifies that the trace data set is to be switched. The
value is:
SWITCH
Makes an immediate switch from the current
auxiliary trace data set to the alternate trace data
set.
SWITCHStatus(
value
)
displays whether automatic data set switching is to occur
when the current auxiliary trace data set becomes full.
The values are:
Noswitch
Switching does not occur without operator
intervention.
NExt Automatic switching occurs when the current trace
data set is full, but not subsequently.
ALl Automatic switching occurs as necessary until the
end of this CICS session without the need for
operator intervention.
Note: You can reset this value by overtyping it with a
different value.
56 CICS Supplied Transactions