Filter
Top Products
This soft copy for use by IBM employees only.
•
IBM Hub-Specific MIB Extensions
This MIB is an enterprise-specific MIB for the IBM Campus ATM Hubs.
Following is a brief description of the groups defined in these MIBs:
− Traps Control Group
This group allows you to configure what traps are sent.
− Switch Control Group
This group determines which slots are controlled by the switch.
− ATM Modules Group
This group gives details on the modules, such as the maximum number
of supported VPs and VCs, the number of VPs and VCs in use and the
type of module.
− ATM Port Group
Information can be found here on the number of ports on a module,
cable type, status and what interfaces it supports (UNI, NNI or SSI).
− ATM Interface Group
This group maps for each ATM port the MIB-II interface index and the
physical slot/port numbers.
− Cross Connect Group
Information on the label swapping tables for VPs and VCs is stored here.
− Neighbor Devices Group
Here information can be found on the ATM devices connected on ports,
such as the IP address and description.
− TFTP Group
This group controls the parameters for TFTP download functions.
− Statistics Group
Statistics for individual VP and VC connections are found here.
•
IBM Signalling Extensions
This IBM MIB extension defines ATM signalling support on the device.
Below is a brief list of the information that can be accessed via this MIB:
− Number of supported signalling channels
− Range of reserved VPs and VCs
− VPI/VCI used for the signalling channel on a port
− The state of the Q2931 interface
− Q2931 statistics, such as the number of call attempts and rejections
− Information about Q2931 calls in progress, such as calling and called
party
− Details of cleared called including the ATM interface involved, calling
and called party, date and time, cause of clearing, QoS requested and
the bandwidth requested
− Details and statistics on the SAAL
•
IBM PVC Management MIB Extensions
Chapter 8. IBM 8285 Management 147