Filter
Top Products
This soft copy for use by IBM employees only.
*** Test your SLIP connection by making sure you can ***
*** ping the bridge (ping 1.2.3.5). ***
************************************************************
Note: You must start TCP/IP (with tcpstart command )before
starting Windows.
1.3.2 Chameleon TCP/IP SLIP Connection Setup
After Chameleon TCP/IP is installed, use the CUSTOM application to set
and enable the COM# port as a SLIP interface with the following configuration:
IP Address: 1.2.3.6
Gateway: 1.2.3.5
Modem : direct connection
Modem speed: 19200 bps
Port: COM#
Flow control: ″none″
Note: # is the number of the COM port to be used.
The following statement MUST be added to the WIN.INI file
to setup the mtu size.
•TCPIP‘
slipmtu=1500
You will need a NULL modem cable if you are directly attached to
the bridge using the SLIP interface.
************************************************************
*** Test your SLIP connection by making sure you can ***
*** ping the bridge (ping 1.2.3.5). ***
************************************************************
1.4 Configuration Utility Program and OS/2 with TCP/IP V2.0
The TCP/IP V2.x for OS/2 must be installed including
DOS/Windows access. The latest OS/2 TCP/IP 2.x CSDs must
also be applied including the DOS/Windows access CSD.
The TCP/IP SLIP interface must be enabled and configured
by running tcpipcfg.
check the enable box
MTU size: 1500
VJ compression: off
IP address: 1.2.3.6
destination IP address : 1.2.3.5
The speed of the com port is not set through tcpipcfg.
You must explicitly change the com port speed by issuing
a mode command from the OS/2 prompt.
188 ATM Workgroup Solutions: Implementing the 8285 ATM Switch