Filter
Top Products
This soft copy for use by IBM employees only.
SYNTAX AtmAddress
ACCESS read-write
STATUS mandatory
DESCRIPTION
″The ATM address of the ARP server used when communicating
with the switch agent using Classical IP over ATM (RFC 1577).″
::= { base 4 }
-- base.5 intentionnally left unused
systemState OBJECT-TYPE
SYNTAX INTEGER {
reset (1),
switch-a (2),
switch-b (3),
base-only (4)
}
ACCESS read-write
STATUS mandatory
DESCRIPTION
″This variables indicates the currently active switch.
When the active switch is in slots 9/10, switch-a is returned.
When the active switch is in slots 11/12, switch-b is returned.
On a 8285 ATM workgroup, when there is no expansion
installed, base-only is returned; when there is an
expansion installed, switch-a is returned.
When reset is set, the complete atm-subsystem is reset and a
switch swap over may occur if the switch electing conditions
have changed since the last reset.″
::= { base 6 }
backupMode OBJECT-TYPE
SYNTAX INTEGER {
noBackUp (1),
primary (2),
secondary (3)
}
ACCESS read-write
STATUS mandatory
DESCRIPTION
″This variable controls the way the active switch
will be elected at the next reset of the atm subsystem,
and controls also the reset of the atm-subsystem.
When set to primary, the switch module currently in use
is defined as the primary switch to elect as the active
switch, if possible, at the next reset of the atm subsystem.
When set to secondary, the switch module currently in use
is defined as the secondary switch. If another switch
module is present, and can be elected then this
other switch will become the active
switch, at the next reset of the atm subsystem.
noBackUp is returned for the atm subsystems which do
not support the redundant switch function.″
::= { base 7 }
functionsConfiguration OBJECT-TYPE
SYNTAX INTEGER {
dynamicRouting-noLanEmulationServer (1),
staticRouting-LanEmulationServer (2),
Appendix E. IBM ATM Campus Switch Private MIBs 199