Filter
Top Products
This soft copy for use by IBM employees only.
DESCRIPTION
″The version and release number for this module
firmware (microcode).″
::= { moduleEntry 5 }
moduleHardwareVersion OBJECT-TYPE
SYNTAX DisplayString
ACCESS read-only
STATUS mandatory
DESCRIPTION
″The Part Number (P/N) and Engineering Change (EC) level
for this module and Plant Location.″
::= { moduleEntry 6 }
moduleAdminState OBJECT-TYPE
SYNTAX INTEGER {
ready (1),
reset (2)
}
ACCESS read-write
STATUS mandatory
DESCRIPTION
″The administrative state of this module.
On an 8260, when set to reset for an entry associated to
the active switch/control point module, the whole atm subsystem is
reset and a switch swap over may occur if the backupMode
criterium has been changed since the last reset.
When set to reset for an entry associated to a module
which is not the active Control Point/Switch module,
only this module is reset.″
::= { moduleEntry 7 }
moduleOperState OBJECT-TYPE
SYNTAX INTEGER {
unknown (1),
operational (2),
not-operational (3),
standby (4),
maintenance (5),
testing (6),
switch-error (7),
incompatible-level (8)
}
ACCESS read-only
STATUS mandatory
DESCRIPTION
″The operational state of this module.
When unknown, the module cannot be accessed
by the Control Point.
When operational, the module is operational.
When not-operational, the module is not operational.
When standby, the module is a redundant switch module
ready to be used.
When maintenance, the module is a redundant switch
module currently in maintenance mode.
When testing, the module is a redundant switch module
currently running diagnostics.
When switch-error, the module is a redundant switch module
not operational, not ready to be used because an error
204 ATM Workgroup Solutions: Implementing the 8285 ATM Switch