Filter
Top Products
This soft copy for use by IBM employees only.
all the traffic received from the attached line is sent
back on this line. If the interface state is not changed,
it will automatically go back to the disabled state after
one minute.
When interfaceAdminState is equal to wrap-far-end,
then the interface located on the other side of the
link is now wrapped.
wrap-reply can only be set for 155 and wan ports.
wrap-far-end cannot be set.″
::= { interfaceEntry 5 }
interfaceOperState OBJECT-TYPE
SYNTAX INTEGER {
unknown (1),
disabled-nosignal (2),
disabled-idle (3),
no-signal (4),
idle (5),
in-service (6),
pvcOnly (7),
failing-internal (8),
misConfigured (9),
wrongNetworkPrefix (10),
wrongNodeNumber (11),
disabled-failing (12),
failing-line (13),
wrap-no-signal (14),
wrap-idle (15),
wrap-failing-internal (16),
wrap-failing-line (17),
idle-no-bandwidth (18),
idle-internal-error (19),
disabled-no-bandwidth (20),
wrap-far-end-no-signal (21),
wrap-far-end-idle (22),
wrap-far-end-failing (23),
wrap-far-end-failing-line (24)
}
ACCESS read-only
STATUS mandatory
DESCRIPTION
″The operational state for this port:
- unknown: the status of this port is unknown (this can
be the result of a module in error)
- disabled-nosignal: no activity is detected at the physical
layer while the port is disabled.
If the port is a SSI port, the
bandwidth configuration is valid.
- disabled-idle:: activity from the remote device
attached to this port has been
detected by the physical layer.
The port is disabled.
If the port is a SSI port, the bandwidth
configuration is valid.
- failing: an internal hard error has been detected on
this port while the port is enabled
- no signal: no activity is detected at the physical
layer while the port is enabled
- idle: activity from the remote device attached to this
Appendix E. IBM ATM Campus Switch Private MIBs 209