Filter
Top Products
114 Intel® Blade Server Ethernet Switch Module IXM5414E
Port Priority Specify the priority for the selected port. The port priority is set in multiples of 16,
and the range is 0 to 240.
Admin Edge Port
Select Enable to specify the port as an Edge Port within the CST. Disable is the
default.
Port Path Cost
Set the Path Cost to a new value for the specified port. The range is 1 to 200000000.
Auto-calculate Port Path Cost
Displays whether the path cost is automatically calculated (Enabled) or not
(Disabled). Path cost will be calculated based on the link speed of the port if the
configured value for Port Path Cost is zero.
Port ID The port identifier for the specified port. It is created by concatenating the port
priority with the interface number of the port.
Port Up Time Since Counters Last Cleared
Time since the counters were last cleared, displayed in Days, Hours, Minutes, and
Seconds.
Port Mode STP Administrative Mode associated with the port or LAG. The possible values are
Enable or Disable.
Port Forwarding State
The Forwarding State of this port.
Port Role Each Enabled bridge port is assigned a Port Role within the spanning tree. The port
role will be one of the following values: Root Port, Designated Port, Alternate Port,
Backup Port, Master Port or Disabled Port.
Designated Root
Root Bridge for the spanning tree.
Designated Cost
Path Cost offered to the LAN by the Designated Port.
Designated Bridge
Bridge Identifier of the bridge with the Designated Port.
Designated Port
Port Identifier on the Designated Bridge that offers the lowest cost to the LAN.
Topology Change Acknowledge
Identifies whether the next BPDU to be transmitted for this port would have the
topology change acknowledgement flag set. It is either True or False.
Hello Time (secs)
Configured value of the hello timer.
Edge Port Indicates whether the port is Enabled as an edge port. It takes the value Enabled or
Disabled.
Point-to-point MAC
Derived value of the point-to-point status.
CST Regional Root
Bridge Identifier of the CST Regional Root. It is made up using the bridge priority
and the base MAC address of the bridge.