Filter
Top Products
Intel® Blade Server Ethernet Switch Module IXM5414E 189
config garp leavetimer
Use this command to configure the GARP Leave Time for the specified port(s). Leave Time is the
time to wait after receiving an unregister request for a VLAN or a multicast group before deleting
the VLAN entry or group. This allows time for another station to assert registration for the same
attribute in order to maintain uninterrupted service. The time may range from 20 to 600
centiseconds.
This command has an effect only when GVRP is enabled.
Default 60 centiseconds (0.6 seconds)
Format config garp leavetimer <port/listofports/all> <20-600>
show garp info
Use this command to display GARP information for the IXM5414E switch module.
Format show garp info
GMRP Admin Mode
This displays the administrative mode of GMRP for the switch module. The default
is disable.
GVRP Admin Mode
This displays the administrative mode of GVRP for the IXM5414E switch module.
The default is disable.
show garp interface
Use this command to display GARP information for one, some or all interfaces.
Format show garp interface <port/listofports/all>
Port This displays the identification of the interface that this row in the table describes.
Join Timer Displays the interval between the transmission of GARP PDUs registering (or re-
registering) membership for an attribute. Current attributes are a VLAN or a
multicast group. There is an instance of this timer on a per-port, per-GARP
participant basis. Permissible values are 10 to 100 centiseconds (0.1 to 1.0 seconds)
in increments of 1 centisecond (0.01 seconds). The factory default is 20
centiseconds (0.2 seconds).
Leave Timer Displays the period of time to wait after receiving an unregister request for an
attribute before deleting the attribute. Current attributes are a VLAN or a multicast
group. This allows time for another station to assert registration for the same
attribute in order to maintain uninterrupted service. There is an instance of this
timer on a per-port, per-GARP participant basis. Permissible values are 20 to 600
centiseconds (0.2 to 6.0 seconds) in increments of 1 centisecond (0.01 seconds).
The factory default is 60 centiseconds (0.6 seconds).
LeaveAll Timer
Shows how frequently LeaveAll PDUs are generated. A LeaveAll PDU indicates
that all registrations will shortly be deregistered. Participants will need to rejoin in
order to maintain registration. There is an instance of this timer on a per-port, per-
GARP participant basis. The LeaveAll Period Time is set to a random value in the
range of LeaveAll Time to (1.5*LeaveAll Time). Permissible values are 200 to
6000 centiseconds (2 to 60 seconds) in increments of 1 centisecond (0.01 seconds).
The factory default is 1000 centiseconds (10 seconds).