Filter
Top Products
Intel® Blade Server Ethernet Switch Module IXM5414E 167
Format config snmpcommunity ipaddr <ipaddr> <name>
config snmpcommunity ipmask
Specify the mask to be ANDed with the requesting entity's IP address before comparison with the
SNMP community IP address associated with the same community name. If the result matches the
SNMP community IP address then the address is an authenticated IP address. For example, if the IP
address = 9.47.128.0 and the corresponding IP mask = 255.255.255.0, a range of incoming IP
addresses would match, i.e. the incoming IP address could equal 9.47.128.0 - 9.47.128.255. The
default value is “0.0.0.0”. The parameter <name> is the applicable community name, and may be up
to 16 alphanumeric characters.
Default 0.0.0.0
Format config snmpcommunity ipmask <ipmask> <name>
config snmpcommunity mode
Use this command to activate or deactivate an SNMP community. If a community is enabled, an
SNMP manager associated with this community is allowed to access the switch. If the community is
disabled, no SNMP requests using this community name are accepted. In this case the SNMP
manager associated with this community cannot manage the switch until the status is changed back
to Enable.
Default The default private and public communities are enabled by default. The four
undefined communities are disabled by default.
Format config snmpcommunity mode <enable/disable> <name>
show snmpcommunity
Use this command to display SNMP community information.
Up to six communities are supported. You can add, change, or delete communities. The switch does
not have to be reset for changes to take effect.
The SNMP agent of the switch complies with SNMP Version 1 (for more about the SNMP
specification, see the SNMP RFCs). The SNMP agent sends traps through TCP/IP to an external
SNMP manager based on the SNMP configuration (the trap receiver and other SNMP community
parameters).
Format show snmpcommunity
SNMP Community Name
The community name of this row of the table.
Client IP Address
An IP address (or portion thereof) from which this device will accept SNMP
packets with the associated community name. The requesting entity's IP address is
ANDed with the Client IP mask before being compared to the Client IP address.
Note that if the Client IP mask is set to 0.0.0.0, an IP address of 0.0.0.0 matches all
IP addresses. The default value is 0.0.0.0.
Client IP Mask
The mask that will be ANDed with the requesting entity's IP address before
comparison with the Client IP address. If the result matches the Client IP address