Filter
Top Products
208 Intel® Blade Server Ethernet Switch Module IXM5414E
Format clear dot1x port stats <port/all>
config dot1x adminmode
Use this command to enable or disable authentication support on the switch. The default value is
disable. In disabled mode, the dot1x configuration is retained and can be changed, but it is not
activated.
Default disable
Format config dot1x adminmode <enable/disable>
config dot1x defaultlogin
Use this command to assign the authentication login list to use for non-configured users for IEEE
802.1X port security. This setting is overridden by the authentication login list assigned to a specific
user if the user is configured locally. If this value is not configured, users will be authenticated using
local authentication only.
Format config dot1x defaultlogin <listname>
config dot1x login
Use this command to assign the specified authentication login list to the specified user for port
security. The <user> must be a configured user and the <listname> must be a configured login list.
Format config dot1x login <listname>
config dot1x port controlmode
Use this command to configure the authentication mode to be used on the specified port or ports.
The control mode may be one of the following:
forceunauthorized
The authenticator Port Access Entity (PAE) unconditionally sets the controlled
port(s) to unauthorized mode
forceauthorized
The authenticator PAE unconditionally sets the controlled port(s) to authorized
mode
auto The authenticator PAE sets the controlled port(s) mode to reflect the result of the
authentication exchanges between the supplicant, authenticator and authentication
server.
Default auto
Format config dot1x port controlmode <port/listofports/all>
<forceunauthorized/forceauthorized/auto>
config dot1x port initialize
Use this command to begin the initialization sequence on the specified port. This command is only
valid if dot1x is enabled and the control mode for the specified port is “auto”.
Default disable
Format config dot1x port initialize <port>
config dot1x port maxrequests
Use this command to configure the maximum number of times the authenticator state machine on
the specified port will retransmit an Extensible Authentication Protocol Over LANs (EAPOL) EAP