Filter
Top Products
170 Intel® Blade Server Ethernet Switch Module IXM5414E
show network
Use this command to display network configuration settings that are necessary for in-band
connectivity.
Format show network
IP Address The IP address of the interface. The factory default value is 10.90.90.9x, where x is
determined by the the number of the I/O-module bay in which the Ethernet switch
module is installed. See
Table 1.“Default IP addresses based on I/O module bay
numbers” on page 21. The IP address may have been acquired from a DHCP server
or may be the static IP address acquired from the management module. See the
Network Configuration Protocol item for more information.
Subnet Mask The IP subnet mask for this interface. The factory default value is 255.255.255.0.
Default Gateway
The default IP gateway address for this interface. The factory default value is
0.0.0.0.
Burned In MAC Address
The burned-in MAC address used for in-band connectivity if you choose not to
configure a locally administered address.
Network Configuration Protocol
Indicates what network protocol was used on the last or current power-up cycle, if
any. The configuration methods are DHCP, BootP and none. The factory default
method is none.
Note: When management of the Ethernet Switch Module is enabled through the
four external ports, and Dynamic Host Configuration Protocol (DHCP) is enabled,
the switch module acquires its IP address from a DHCP server when the switch
module is turned on or reset; otherwise, the switch module acquires a static IP
address from the management module.
Web Mode Indicates whether the switch may be accessed from a web browser. If web mode is
enabled you can manage the switch from a web browser. The factory default is
enabled.
Java Mode Indicates whether the java applet that displays a picture of the switch at the top right
of the screen is enabled or disabled. If the applet is enabled you will be able to click
on the picture of the switch to select configuration screens instead of using the
navigation tree at the left side of the screen. The factory default is enabled.
Telnet
config telnet maxsessions
Use this command to configure the number of simultaneous Telnet and Secure Shell (SSH) sessions
that can be established. A value of 0 indicates that no Telnet session can be established. The range is
0 to 5.
Default 5
Format config telnet maxsessions <0-5>