142 Intel® Blade Server Ethernet Switch Module IXM5414E
Source L4 Port Keyword
Specify that a packet’s source Layer 4 port is a match condition for the selected
ACL rule. If you click Configure on this line you will be shown a new screen where
you can select the port to be used as the match condition. The possible values are
domain, echo, FTP, ftpdata, HTTP, SMTP, SNMP, Telnet, TFTP, and www. Each of
these values translates into its equivalent port number, which is used as both the
start and end of the port range.
Source L4 Port Number
Specify a packet’s source Layer 4 port number as a match condition for the selected
ACL rule.
Destination L4 Port Keyword
Specify that a packet’s destination Layer 4 port is a match condition for the selected
ACL rule. If you click Configure on this line you will be shown a new screen where
you can select the protocol to be used as the match condition. The possible values
are domain, echo, FTP, ftpdata, HTTP, SMTP, SNMP, Telnet, TFTP, and www. Each
of these values translates into its equivalent port number, which is used as both the
start and end of the port range.
Destination L4 Port Number
Specify a packet’s destination Layer 4 port number match condition for the selected
ACL rule.
Click the Configure button to configure the corresponding match criteria for the selected rule.
Click the Delete button to remove the currently selected Rule from the selected ACL. If you want
the switch to retain the new values across a power cycle you must perform a save.
Bandwidth provisioning
This menu provides access to the following bandwidth provisioning configuration and summary
screens:
• Bandwidth profile configuration
• Bandwidth profile summary
• Traffic class configuration
• Traffic class summary
• Interface allocation summary
Bandwidth profile configuration
Use this panel to create a bandwidth allocation profile.