Filter
Top Products
50 Intel® Blade Server Ethernet Switch Module IXM5414E
IP Address The IP address of the interface.The factory default value is 10.90.90.9x, where x is
determined by the number of the I/O-module bay into which you have installed the
Ethernet switch module (see
Table 1.“Default IP addresses based on I/O module bay
numbers” on page 21).
Subnet Mask The IP subnet mask for this interface. The factory default value is 255.255.255.0.
Default Gateway
The default IP gateway address for this interface. The factory default value is
0.0.0.0.
Network Configuration Protocol
Indicates what network protocol was used on the last or current power-up cycle, if
any. The configuration methods are DHCP, BootP and none. The factory default
method is none. When management of the Ethernet switch module is enabled
through the four external ports, the switch module will acquire its IP address from a
Dynamic Host Configuration Protocol (DHCP) server when the switch module is
turned on or reset.
Burned In MAC Address
The burned-in MAC address used for in-band connectivity if you choose not to
configure a locally administered address.
Web Mode Specify whether the switch may be accessed from a web browser through TCP port
80. If you choose to Enable web mode you will be able to manage the switch from a
web browser. The factory default is Enabled.
Java Mode Enable or Disable the java applet that displays a picture of the switch at the top right
of the screen. If you run the applet you will be able to click on the picture of the
switch to select configuration screens instead of using the navigation tree at the left
side of the screen. The factory default is Enabled.