Filter
Top Products
Intel® Blade Server Ethernet Switch Module IXM5414E 209
Request/Identity before timing out the supplicant. The maximum requests value must be in the range
of 1 and 10.
Default 2
Format config dot1x port maxrequests <port> <1-10>
config dot1x port quietperiod
Use this command to configure the value, in seconds, of the timer used by the authenticator state
machine on the specified port to define periods of time in which it will not attempt to acquire a
supplicant. The quiet period is the period for which the authenticator does not attempt to acquire a
supplicant after a failed authentication exchange with the supplicant. The quiet period must be a
value in the range of 0 and 65535.
Default 60
Format config dot1x port quietperiod <port> <0-65535>
config dot1x port reauthenabled
Use this command to enable or disable reauthentication of the supplicant for the specified port. The
reauthenabled value must be true or false. If the value is true reauthentication will occur. Otherwise,
reauthentication will not be allowed.
Default false
Format config dot1x port reauthenabled <port> <true/false>
config dot1x port reauthenticate
Use this command to begin the reauthentication sequence on the specified port. This command is
only valid if dot1x is enabled and the control mode for the specified port is “auto”.
Default disable
Format config dot1x port reauthenticate <port>
config dot1x port reauthperiod
Use this command to configure the value, in seconds, of the timer used by the authenticator state
machine on this port to determine when reauthentication of the supplicant takes place. The
reauthperiod must be between 1 and 65535.
Default 3600
Format config dot1x port reauthperiod <port> <1-65535>
config dot1x port servertimeout
Use this command to configure the value, in seconds, of the timer used by the authenticator on the
specified port to timeout the authentication server. The server timeout must be between 1 and 65535.
Default 30
Format config dot1x port servertimeout <port> <1-65535>
config dot1x port supptimeout
Use this command to configure the value, in seconds, of the timer used by the authenticator state
machine on the specified port to timeout the supplicant. The supplicant timeout must be between 1
and 6553.
Default 30