Filter
Top Products
Section 5 OTHER CONVENIENT FUNCTIONS
5-50
24. Memorizing frequently used settings [Program function]
Up to eight combinations of copy modes and other functions displayed
on the operation panel can be registered as a single program using
this function. You can also register a name for each registered
program.
(1) Registering a program
1
Set the desired copy modes, etc., to be registered.
2
Touch the “Program” tab. The content of the “Program” tab
will be displayed.
3
Touch the “Register” key.
Inch specifications
Recall
Ready to copy.
Program
Function
Reg./delete
Register
Change
name
Delete
User choiceBasic
Set
11 x 8
1
/
2
"
Paper Size
Metric specifications
Reg./delete
Register
Recall
Delete
Change
name
Basic
User choice Function Program
Ready to copy.
Set
Paper size
4
Touch any key that is marked “No registration” and that
corresponds to the program key (1 – 8) under which you
want to register the settings. The screen to register a name
for that program will be displayed.
Inch specifications
Select program number.
No registration
No registration
No registration
No registration
No registration
No registration
No registration
Register present setting
End
No registration
Metric specifications
Select program number.
No registration
No registration
No registration
No registration
No registration
No registration
No registration
Register present setting
End
No registration
5
Use the displayed keyboard to enter the desired name and
then touch the “End” key.
Inch specifications
EndStop
Name to display
Catalog A
Limit:16 letters including #
AllDel.
Del. prev
1234567890-=`
qwertyuiop[] \
asdfghjkl;
zxcvbnm,./
'
Capital Num./Sym. SpaceLetter
Metric specifications
EndStop
Name to display
Catalog A
Limit: 16 letters inc. # key
Del. prev
1234567890-=`
qwertyuiop[] \
asdfghjkl;
zxcvbnm,./
'
Capital Symbol 1 Symbol 2 SpaceLetter
`
AllDel.
NOTE
Refer to “11. Entering characters” on page 7-104 for information on
entering characters.
6
Touch the “Yes” key or the “No” key, as appropriate.
If you selected “Yes”, the selected program will be registered
and the touch panel will return to the screen in step 3.
Copying is now possible using the settings that were
registered under that program.
Inch specifications
Program # : 1
The set program is registered. Is it correct?
Ye s N o
Program name :Catalog A
Register program.
Stop
Metric specifications
Program # : 1
The set program is registered. Is it correct?
Ye s N o
Program name : Catalog A
Register program.
Stop