Filter
Top Products
249
5. Troubleshooting
If Your Machine Does Not Operate as You
Want
General
Machine Status Problem/Cause Action
The machine instructs you to
wait.
The machine is warming up. Wait for the machine to warm-
up.
Reference
You can use Auto Start
mode during warm-up pe-
riod. See ⇒ p.88 “Auto
Start”.
Copy paper is moving in Tray
1 (Tandem Tray).
Wait for the machine.
The machine cannot detect the
original size.
Improper original is set. See ⇒
p.25 “Sizes difficult to detect”.
Set non-standard size original
on the exposure glass. See ⇒
p.34 “Setting Originals on the
Exposure Glass”.
Select paper manually, not in
Auto Paper Select mode.
Do not use Auto Reduce/En-
large mode.
Original is not set. Set your originals.
The machine instructs you to
check the original direction.
There is no copy paper that is
in the same direction as the
originals.
Set the original in the same di-
rection as the copy paper.
The machine instructs you to
check paper size.
Improper original size is set. Select the proper paper size.
The machine cannot perform
rotate-sorting for this paper
size.
The size of paper for which no
rotate-sorting is available is
selected.
Select the proper paper size.
See ⇒ p.56 “Sort”.
The machine cannot punch
this size of paper.
-- Select the proper paper size
that can be used in Punch
mode. See ⇒ p.67 “Punch”.
The number of sheets that can
be stapled has been exceeded.
-- Check the stapler capacity.
See ⇒ p.61 “Staple”.