Filter
Top Products
A wedge whose sweep angle is 360 degrees or greater is drawn as a circle
with no line connected to the center. If the sweep angle is zero, it is a single
straight line from the center to the starting point.
This command clears then draws to the polygon buffer.
FI (select primary font by ID) (font id)
font id: a font ID as used in standard LaserJet III emulation mode
command <ESQ[(or)]nX
This command allows the selection and use as the standard or primary font
any font to which an ID has been assigned. For outline fonts, the SD
command must also be used to specify the point size.
This command executes an SB command to insure compatibility of the font
selected with the font types allowed.
FN (select secondary font by ID) (font id)
font id: a font ID as used in standard LaserJet III emulation mode
command <ESO[(or)]nX
This command does for the secondary font what FI does for the primary font.
f7 (fin PoWon)
This command uses the even-odd rule to fill the polygon currently in the
polygon buffer. The fill type is the one currently selected. All points are used,
whether stored with the pen up or down. The contents of the buffer are used
but not changed or deleted.
This command is ignored if a previous PM, RA, RR, or WG command caused
the polygon buffer to overflow and no other command cleared it.
fl (fiti 07-d ([typeI 11 Lpam2 LP-3111)
The relation between these three parameters and the meanings are given in
the table below.
tYPe
fill
param
param
1
solid (default) ignored
ignored
2 solid ignored
ignored
3 hatched
line spacing line angle
4 cross-hatched line spacing line angle
10
WY
shading level ignored
11 user-defined
fill index ignored
21 LaserJet III
pattern pattern type
ignored
102
-
-
-