Filter
Top Products
Set Vertical Tabs
Tab Vertically
Tab Horizontally
Define line spacing
<ESC> B nZn2...n644UL>
<VT>
4Tl-b
You can set the line spacing, in increments of l/72 inch, using the following
Define Line Spacing command. However, the value you define is only stored
inmemory until you send the <ESC> 2 command to actually put it into effect.
<ESC> A n
For n enter the number of increments you want, between 0 (zero) and 255.
Select line spacing
You can select the line spacing that you have previously defined and stored
in memory (with the <ESC, A command above), by using the following
command:
<ESC> 2
Note that the 2 in this command is the digit two, not the ASCII symbol 2.
If you have not sent a previous <ESC> A command, this <ES0 2 command
sets the line spacing to the default setting of 6 lines per inch.
Special line feed
This command produces a one-time line feed in your choice of 11216 inch
increme,nts. It does not affecting line spacing, anddoesnot produce acarriage
return (unless Auto Parameters is set that way on the front panel).
You can move the print position down this way by using this command:
<ESC> J n
For n you enter the number of l/216 inch increments you want, between 0
(zero) and 255.
148