Filter
Top Products
Pre-Installation
976-0043-01-02 3–5
3. Determine the correct size of battery cables to use.
See Table 2-2, “Recommendced Battery Cable Size Versus Length”
on page 2–14 for additional information and recommended battery
cable sizing.
4. Determine the correct size of DC breaker/fuse to use.
See Table 2-3, “Battery Cable to Maximum Breaker/Fuse Size” on
page 2–15 for additional information and recommended DC breaker/
fuse sizing.
5. Color code the cables with tape or heat shrink tubing. The standard
colors for DC cables are red for positive (+) and black for
negative (–).
Unpacking and Inspecting the Inverter
Before installing your Sine Wave Plus Inverter/Charger, perform the
following.
❐ Carefully unpack the Sine Wave Plus from its shipping carton.
❐ Inspect for shipping damage and contact the shipping company if
there is damage.
❐ Verify that all of the following items are present. Please call your
authorized Xantrex dealer if any items are missing.
•The Sine Wave Plus Inverter/Charger
•The Sine Wave Plus Inverter/Charger Owner’s Guide
• The Battery Temperature Sensor
• Battery Terminal Covers (with associated hardware)
❐ Save your proof-of-purchase. This is required if the unit should need
warranty service.
Important:
The battery voltage MUST match the voltage requirements of the
inverter. To determine the correct voltage for the system, check the last two digits
on the inverter’s model number. For example, the Sine Wave Plus 2524 is a
24-volt inverter and requires a 24 Vdc battery system.
WARNING: Personal Injury
Do not attempt to mount this unit on the wall by yourself as the unit is too heavy
for one person. Have additional help available to assist in lifting the unit during
installation.