Filter
Top Products
PRINTING WITH THE 4213
A skewed image is usually the result of:
• The sheet not being flush against the left feed guide when it
is inserted into the bypass slot
• The sheet not being held in place at the bypass slot entrance
when it began to move through the bypass slot.
Note: The maximum size of paper which can be manually fed is
216 by 279 mm (8.5 by 14 inches). The minimum size is 99 by
191 mm (3.88 by 7.5 inches). Do not try to 2-sided anything
other than A4 or legal size paper while using manual feed or a
paper jam could occur.
Printing on envelopes
Addresses are formatted to print on standard sized envelopes. In
the LJ2D emulation, you can select one of the standard
envelopes listed in table 4-5 using the PAPER SIZE menu item. In
the other emulations, you must format your pages for the
envelopes you are using before you submit your print job.
Envelopes are printed in the landscape orientation.
The address is placed on the envelope, according to the size of
the envelope being fed. Envelopes are printed using the bypass
tray. Refer to “Selecting the bypass tray at the printer,” section
shown earlier in this chapter for information on how to select the
bypass tray at the Main Menu.
You can set the envelope size in one of three ways:
• If your application software allows you to select the envelope
size, the selected paper size command is automatically sent
to the printer and the image is placed in the correct location
on the envelope.
• You can access the LJ2D emulation configuration in the Main
Menu and select one of the standard sizes listed in table 4-5
from the LJ2D paper size options. Refer to the next section,
“Setting the envelope size at the LJ2D sub-menu.”
• You can send a printer command, or an escape sequence, to
let the printer know the envelope size you are using. Refer
to the LJ2D or XES section in the Rank Xerox 4213 Laser
Printer Programmer Reference for information on page
formatting commands.
4-28 XEROX 4213 LASER PRINTER USER GUIDE