Filter
Top Products
SIMM KIT INSTALLATION AND REMOVAL INSTRUCTIONS
Install additional options
If you purchased additional options for your printer, you can
install them at this time while the system controller board is out
of the printer. If there are no additional options to be installed,
continue with step 13.
System controller board reinstallation
13. Place the system controller board into the receiving rails of
the printer.
14. For reinstallation of the system controller board, reverse the
removal process in steps 1 to 6.
Caution: Cable connectors may interfere with the
reinstallation of the system controller board; therefore, route
them carefully.
SIMM board removal and replacement procedures
When an error message on the message display shows that a
SIMM board is faulty, use the following steps to remove or
replace one or all of the boards.
Before you begin
Perform the following steps before beginning the SIMM board
removal and replacement procedures (refer to figure A5-8).
A5-8 4213 LASER PRINTER USER GUIDE