Filter
Top Products
228 CHAPTER 6: CONFIGURING WX SYSTEM PARAMETERS
Adding a New ACE to
a Configured ACL
To add a new ACE to a configured ACL:
1 Access the ACL table:
a Select the Configuration tool bar option.
b In the Organizer panel, click the plus sign next to the WX switch.
c Click the plus sign next to System.
d Select ACLs.
2 Select any ACE in the ACL to which you want to add the new ACE.
3 In the Task List panel, select Add Rules.
4 Go to step 3.
Mapping an ACL An ACL does not take effect until you map it to a user or an interface.
You can map ACLs to ports (or port groups), VLANs, or virtual ports. You
cannot map an ACL to a MAP port or a wired authentication port.
You also can map ACLs to user, by configuring the filter.in and filter.out
user attributes. User-based ACLs are more specific than ACLs applied to
interfaces and are therefore processed first. (See “Authorization
Attributes” on page 293.)
1 Access the ACL table:
a Select the Configuration tool bar option.
b In the Organizer panel, click the plus sign next to the WX switch.
c Click the plus sign next to System.
d Select ACLs.
2 Select any ACE in the ACL you want to map.
3 In the Task List panel, select ACL Mappings.
Timestamp (13) None
Timestamp Reply (14) None
Information Request (15) None
Information Reply (16) None
Table 17 ICMP Messages and Codes (continued)
ICMP Message (Type Number) Code (Number)