Filter
Top Products
246 CHAPTER 7: CONFIGURING WIRELESS PARAMETERS
By default, data in unicast and multicast packets are encrypted using
WEP key 1. To use another key for either type of packet, select the key
number in the WEP Unicast Key Index or WEP Multicast Key Index box.
17 Click Next.
18 Select or type the name of the VLAN into which you want the switch to
place voice clients.
19 Click Next.
This step and the following step do not apply if the vendor selected in
step 6 is Vocera.
If applicable, the ACEs (ACL rules) that 3WXM will configure for the voice
service are listed. For non-WMM clients, ACEs are required in order to
provide priority treatment of voice traffic. The ACEs differ depending on
the vendor you selected in step 6. The wizard describes the ACEs.
If you need to modify the ACEs, go to step 20. Otherwise, go to step 21.
20 To add an ACE, click Add Rule. 3WXM adds an ACE to the end of the
list. The ACE matches on all source and destination IP addresses and
denies them.
To modify an ACE, select the part of the ACE you want to modify, and
edit or select the new value. (For information about ACE settings, see
“Viewing and Configuring ACLs” on page 220.)
21 If you selected MAC Access in step 8, select or create the MAC address globs
you want to allow to access the voice VLAN. Otherwise, go to step 23.
To create a new rule:
a Click Create.
b Specify the MAC address glob in the Matching MAC Glob box. To
match on all MAC addresses, leave the wildcard (*) in the box. (For
syntax information, see “Access Rules” on page 238.)
To use an existing rule, leave the rule in the list.
22 Select or create the radio profile to map to this service profile.
By default, the default radio profile is selected.
To map the service profile to the default radio profile, leave default
selected and go to step 23.
To map the service profile to a different radio profile, select the radio
profile and go to step 23.