Filter
Top Products
140 Chapter 9
Changing the Machine Settings
z Incoming ring
Sets whether to ring with an incoming call when the receive mode is set to <FAX only> or <FAX/
TEL auto switch>. A telephone needs to be connected for the machine to ring.
z Manual/auto switch
Sets, when the receive mode is set to <Manual RX> or <Ans. machine connect.>, whether to
automatically receive faxes after the machine rang a specified length of time.
z Remote RX
Enables/disables remote reception.
z RX image reduction
Enables/disables automatic reduction of incoming faxes so that they fit in the selected paper.
z RX start speed
Selects the fax reception speed.
z RX report
Sets whether to print a reception report after each reception.
Other Settings
Read/write attribute
Selects whether to allow data to be written onto memory cards from a computer.
Volume control
Selects the volume.
z Keypad volume
Selects the beep volume when pressing the buttons on the Operation Panel.
z Alarm volume
Selects the alarm volume.
Ring count Specifies the number of times the machine rings when <ON>
is selected.
RX start time Specifies the length of time until automatic reception is started
when <ON> is selected.
Remote RX ID Specifies the remote reception ID when <ON> is selected.
Image reduction direction Selects the image reduction direction when <ON> is selected.
Important
If you set this setting to <Read/write mode>, card direct printing cannot be done. After you
finish operation of the memory card dedicated drive, be sure to revert this setting to <Read-
only mode>.