Filter
Top Products
Chapter 1 19
Before Printing
Setting the Power Save Mode
The machine enters Power save mode if not operated for a certain interval. In the Power save
mode, the internal fluorescent lamp are turned off, and the selected Mode Lamp stays lit. You
can configure the interval that the machine waits before entering Power save mode. See
“Power save setting” on page 141.
When you try to perform any operation such as copying, faxing, or scanning, the machine will
exit from Power save mode.
If you use the machine frequently, we recommend that you set the Power save transfer time
to 1 hour or 8 hours.
The Screen-saver Mode
The LCD goes out if the machine is not operated for 5 minutes. Press any button to restore
the display. You cannot change the period before the LCD goes out.
Loading Documents to Copy, Fax, or Scan
This section describes how to load the document.
Document Requirements
The documents you load on the Platen Glass or the ADF for copying, faxing, or scanning must
meet these requirements:
Platen Glass ADF
Document
type
z Documents
z Photographs
z Book
z Documents that are not suitable for the
ADF
Multipage documents of the same size,
thickness, and weight
Size (W x L)
Max. 8.5" x 11.7" / 216 x 297 mm Max. 8.5" x 14.0" (216 x 356 mm)
Min. 5.8" x 5.8" (148 x 148 mm)
Only A4- or Letter-sized originals for two-
sided copying or scanning
Quantity
1 sheet
z Max. 35 pages of A4- or Letter-sized
sheets (20 lb. or 75 g/m
2
paper), up to
5 mm in height
z Max. 30 pages of Legal-sized sheets
(20 lb. or 75 g/m
2
paper), up to 4 mm in
height
z 1 sheet for sizes other than these
Thickness
Max. 0.8" / 20 mm 0.002" to 0.005" (0.06 to 0.13 mm)
Weight
— 13 to 24 lb. (50 to 90 g/m
2
)