Filter
Top Products
Cleaning the Inside of the ScanSnap
284
2. Clean the following locations with a cloth lightly moistened with Cleaner
F1.
Turn off the ScanSnap before cleaning the following parts:
z Pad assy (× 1)
Wipe the pad assy downwards. When cleaning the pad assy, be careful not to get
your hand or the cloth caught on the pick spring (metal part).
z Glass (× 2, located on the ADF top section and its opposite side)
Clean the glass surface lightly with a soft cloth.
z White backing strip (× 2, located on the ADF top section and its opposite side)
White strips along the edge of the glass. Clean the surface lightly with a soft cloth.
z Pick roller (× 1)
Clean the roller lightly while rotating it with your finger downwards. Be careful not to
damage the surface of the rollers. Take particular care in cleaning the rollers since
foreign substances left on the rollers negatively affect the feed performance.
z Idler roller (× 4, located on the ADF top section)
Clean the rollers lightly while rotating them with your fingers. Be careful not to
damage the surface of the rollers. Take particular care in cleaning the rollers since
foreign substances left on the rollers negatively affect the feed performance.
It may take a long time for Cleaner F1 to dry if an excessive amount is used. Moisten the
cloth with a moderate quantity. Make sure to wipe off the cleaner completely with a soft
lint-free cloth to leave no residue on the cleaned parts.
Pad assy
Idler roller ( × 4)
Eject roller ( × 2)
Feed roller ( × 2)
Glass ( × 2)
(Including the one on the ADF
top section.)
Pick roller
White backing strip ( × 2)
(Including the one on the ADF
top section.)
Pick spring (metal part)