Filter
Top Products
Cleaning the Inside of the ScanSnap
285
Turn on the ScanSnap before cleaning the following rollers by rotating them:
z Feed roller (× 2)
Clean lightly taking care not to damage the surface of the rollers. Take particular care
in cleaning the rollers since foreign substances left on the rollers negatively affect the
feed performance.
z Eject roller (× 2)
Clean lightly taking care not to damage the surface of the rollers. Take particular care
in cleaning the rollers since foreign substances left on the rollers negatively affect the
feed performance.
Press the [Scan] button for three seconds with the ADF top section open to activate the
cleaning mode. In this mode, pressing the [Scan] button seven times rotate the feed and
eject rollers one full turn.
3. Close the ADF top section.
D You should hear the ADF top section click when it returns to its original position.
Connect the power cable or USB bus power cable only when cleaning the feed rollers
and eject rollers.
Make sure that the ADF top section is completely closed. Otherwise, paper jams or
other feeding errors may occur.
ADF paper chute (cover)
ADF top section